17mm Hex Wheel Adapters with 8mm Extension - TRA Jato

About this part

Hot Racing aluminum 17mm hex hub adapter set for the TRA Jato vehicles. These allow you to use wheels with a 17mm hex on your Jato and provide a width increase of approximately 8mm per side.

Features

• Converts front wheel bearing and rear 12mm hex setup to 17mm hexes
• CNC machined 6061 aluminum adapters and wheel nuts, anodized silver and blue, respectively
• Increases vehicle width for increased stability; 8mm and the rear, with the front depending on the wheel set chosen
• 17mm wheel nut with internal o-ring to prevent nut from loosening

You will receive

• Two (2) front adapters
• Two (2) rear adapters
• Four (4) 5x8x2.5mm sealed ball bearings for front adapters
• Four (4) M4 axle hub barrel nuts
• Four (4) 17mm hex wheel nuts
• Two (2) 2x10mm axle pins
• One (1) 4mm hex key

Requirements

• Installation
• Two 5x11x4mm front bearings from stock vehicle
• Medium thread lock (blue threadlocking compound) on M4 axle hub barrel nuts

Comments

• Silicone shock oil on wheel nut o-rings will ease their installation
• Replacement Hot Racing parts include: RSLF117X06 (17mm hex nuts), RSSLF117X (M4 axle hub barrel nuts)

Fits