Steel Helical Diff Ring/Pinion Underdrive (10/35T) TRX4

About this part

Hot Racing steel helical spiral Underdrive 35T/10T gear set for 1/10 TRA TRX-4

Features

• Precision machined helical spiral cut gears offer inherently greater strength and smooth operation than the factory Straight cut bevel gears
• High carbon steel construction
• Less vibration, less noise, less wear then stock straight cut bevel gears
• 35T/10T provides 9% overdrive (vs stock 34T/11T) increases the wheel speed and is commonly used in the front end for digs
• Works on front or rear. Use cases are typically front and rear at the same time, or Rear only to increase front digs

You will receive

• One (1) 35 tooth spiral cut ring gear
• One (1) 10 tooth spiral cut pinion gear

Requirements

• Installation following kit manual
• Medium threadlock (blue threadlocking compound) if screws are threaded into metal
• Hot Racing SPL10G05 high temp grease recommended

Comments

• Replaces TRA8288 Option - overdrive the front axle, and underdrive the rear axle.
• Combinations One. TRXF312 in the front and TRXF9411 in the rear.
• Combinstion Two. TRXF9411 in the front and TRXF9510 in the rear.
• Combinstion Three TRXF312 in the front and TRXF35810 in the rear.

Fits

Replaces stock part