Light Kit, Incision Series 3 - Vanquish Products

About this part

Light up your VS4-10 Phoenix or Origin Classic. The kit is built around the molded front inner fenders, and the Origin Classic also gets the rear fenders. The headlight housings bolt into the Phoenix grille with the existing 1-64 hardware.

Features

• Molded front light buckets with high-power LED and heat sink
• Red LED tail lights
• White LED inner fender rock lights
• LED controller with manual on/off and aux on/off from the aux receiver channel
• Headlights run off a 2-3S LiPo balance plug on the controller
• Aux control and red LED headlights run off the RX plug
• IN THE BOX:
• 2 molded front LED headlight housings with heat sink
• 2 x 5mm red LED tail lights
• 4 PCB LED rock lights (use 4 on Origin, 2 on Phoenix)
• 1 LED controller with required power plugs
• A parts box
• Fits VS4-10 Phoenix and Origin body sets. Remove the stock light buckets, mount the light assembly with the existing 1-64 hardware, plug the red tails into the stock VS4-10 rear LED housings, mount the controller to the chassis, and connect the body LEDs with the 4-pin connector.

Fits