Adjustable Rear Hubs, Heavy-Duty 7075, for Use with M3 Ball Studs, RC10 - Exotek

About this part

Hard-hitting rear hubs for the RC10 Classic buggy series, including the RC10T and RC10 4WD. They're precision machined from 7075 alloy and the bearing pockets are re-machined to fit stock bearings. The anodizing stays off the bearing surfaces. Adjustable roll center mounts and camber gain come from M3 washers and an angled ball stud mount. You get adjustments the stock hubs can't do. The lower hinge pin mounts high or low for roll center, and M3 set screws lock the hinge pins in place.

Note

• These hubs need metric ball studs like Associated ASC91047. Don't run the weak stock 4/40 ball studs.
• TIP: Pair with Associated RC10 4WD ball cups and turnbuckles ASC6535 and ASC6547.

Fits